Autronica BNB-330A Conventional Loop Interface


The Autronica BNB-330A Conventional Loop Interface is a two wire interface unit for interfacing conventional detectors and manual call points. The BNB-330A is used on Autronica’s interactive fire detection systems. The Autronica BNB-330A replaces the BNB-330 and may be used on all the same systems.
The Autronica BNB-330A has different mechanical measurements then the BNB-330 and will not fit directly into the BN-330 enclosure. A special DIN rail (US-852/1) and brackets (US-852/2) must be used for fitting of the BNB-330A in this enclosure.

Autronica BNB-330A
    
Features
Local-powered (requires external 24V power supply)
Short and open circuit detection on conventional detection loop
Ground fault detection on conventional detection loop via fire panel ground fault detection
Up to 32 detectors/manual call points on one conventional detection loop
Interfaces conventional detectors and manual call points from Autronica and other leading manufacturers., refer to voltage vs. current chart
Uses active EOL unit
Addressable loop technology
Automatic addressing
Proven technology
TS35 DIN rail mounted
Indicators for Power, Alarm and Fault on the conventional detection loop
Galvanic isolation between power supply and detector interface
Monitored power input. Fault signaled if <18V for 24 VDC
Monitored power input. Fault signaled if <12V for 15 VDC
Backbone bus distributing external 24V bus via DIN rail to up to 20 units, reducing installation time

Please contact us for more information.